Hanging guide – Vinyl wallpaper
Sweet Papaya vinyl wallpaper has a durable, lightly textured finish. It is supplied in pre-cut lengths measuring 2.5 m, 3 m or 3.5 m in height, depending on the option selected.
For repeating-pattern designs, all lengths are identical: you can start with any length, keeping the pattern facing the same way. Installation involves overlapping the edges and making a single cut down the centre to create a continuous join.
1. Preparing the wall
The surface must be dry, clean, sound and smooth. Remove the previous wall covering and any flaking paint. Repair uneven areas and remove sanding dust. If the wall is highly absorbent, apply a suitable primer and allow it to dry. Resolve any damp problems and smooth out stippled or textured finishes before hanging the wallpaper.
2. Preparing the adhesive
Use an adhesive suitable for vinyl wallpaper and compatible with its backing. Follow the manufacturer's instructions on preparation, quantity and soaking or standing time.
3. Hanging method (very important)
We recommend applying adhesive to both the wall and the back of the wallpaper:
- Mark a vertical guideline using a spirit level to keep the lengths straight.
- Spread the adhesive evenly over the area of wall you are about to cover and the back of the length, including the edges. Avoid excess build-up and observe the specified soaking or standing time.
- Hang a length from top to bottom, following the vertical guideline.
- Smooth gently from the centre towards the edges to release trapped air, without stretching the wallpaper.
- Hang another length with its edge overlapping the previous one. Slide it gently until the pattern matches in the overlapping area.
4. Adjusting, trimming and drying
Cut through the overlap before the adhesive dries.
- Position a metal straightedge down the centre of the overlapping area.
- Using the utility knife, make a single vertical cut through both layers of wallpaper at once, following the straightedge and taking care not to score the wall.
- Remove the upper strip of excess wallpaper. Gently lift the edge to remove the strip underneath as well.
- Add a little adhesive if needed and lay the edges back down. They should now meet edge to edge, with no overlap or gap.
- Smooth the join gently and repeat the process with the remaining lengths.
Trim excess wallpaper along the ceiling, skirting board and outer edges with a straightedge and utility knife before it dries, while the wallpaper is still workable. Remove adhesive residue with a soft cloth, following the adhesive instructions.
Allow to dry naturally, avoiding strong draughts and direct heat. Observe the drying time specified by the adhesive manufacturer
What you will need
- Adhesive specifically designed for vinyl wallpaper
- Brush or roller and a tray
- Rubber smoothing tool or wallpaper brush
- Utility knife with a sharp blade and a metal straightedge
- Soft, clean cloth
- Tape measure, pencil and spirit level or plumb line
